Klesa
Luvocom® 3F PAHT 9825 NT Filament
Luvocom® 3F PAHT 9825 NT Filament
Couldn't load pickup availability
Luvocom® 3F PAHT 9825 NT Filament
Luvocom® 3F PAHT 9825 NT Filament is an unreinforced high temperature polyamide. Its water absorption takes about four times longer to reach the saturation point compared to unmodified PA6, and its saturation point is five times lower than conventional PA6 materials. This special grade of engineering polymer is specially tailored to the needs of the 3D printing industry to meet the strength requirements of injection molding and is focused on serial production of end products. The filament can be used in conventional FFF / FDM 3D printing systems due to improved printability, improved layer adhesion and the absence of a heated chamber. This 3D4Makers PAHT filament offers the following features:
Easy to print, low distortion and increased layer adhesion Excellent tensile strength and impact resistance Suitable for industrial applications Micro-CT analysis Luvocom PAHT 9825 VS Standard PA6.
Material properties
| Description | Value | Test method |
|---|---|---|
| Density | 1.20 g/cm³ | ISO 1183-3 |
| Tensile strength (23 °C / 50% rh) | 85 MPa | ISO 527 |
| Elongation (23 °C / 50% rh) | 3.6% | ISO 527 |
| Modulus of elasticity (23 °C / 50% rh) | 3.4 GPa | ISO 527 |
| Heat deformation temperature | 90 °C | ISO 75 |
| Continuous operating temperature | 120 °C | UL 746B |
| Maximum (short-term) operating temperature | 160 °C | |
| Thermal conductivity | 0.3 W/mK | HOT DISK |
Printer recommendations
| Description | Value |
|---|---|
| Printer nozzle temperature | 260 to 285°C |
| The temperature of the heated substrate | 60 to 80°C |
| Print speed | 40 - 60 mm/s |
| Fixing the base | Magigoo PA for glass or PEI board |
| Pre-drying recommendations | 100°C, 4 to 6 hours or 80°C, 12 hours |
*Printing profile available in the Ultimaker Marketplace (material certified by Ultimaker)
For best printing results, we recommend keeping the 3D printer in a room with no draft or temperature fluctuations. When the 3D printer is not in use, it is important to store the filament in a bag and in a cool, dry, dark place until it is used again.
TDS
You can find the technical data sheet for Luvocom® 3F PAHT 9825 NT filament here.
SDS
The material safety information for Luvocom® 3F PAHT 9825 NT Filament can be found here.
Printing instructions
Printing instructions for Luvocom® 3F PAHT 9825 NT Filament can be found here.
